Difference between revisions of "X-Carve 1000mm CNC Router - Deprecated"
(Created page with "=HELP= *[https://discuss.inventables.com Inventables Forum] *[http://forum.vectric.com VCarve Forum] =Open VCarve= *Open Model (*.xxx) =Select Tool= *Existing Tool: Select t...") |
|||
| Line 1: | Line 1: | ||
| + | Location: [[Wood Zone]] | ||
| + | [[File:X-Carve_1000mm_CNC_Router.jpg|400px|thumb|right|X-Carve 1000mm CNC Router]] | ||
| + | Spindle (DeWalt 611), 7.0 Amps, 1-1/4HP No load speed: 16,000-27,000rpm. | ||
| + | A properly tuned and calibrated machine should get to a resolution of ~0.075mm to 0.13mm. | ||
| + | |||
=HELP= | =HELP= | ||
| + | *[https://www.inventables.com/projects Projects] | ||
*[https://discuss.inventables.com Inventables Forum] | *[https://discuss.inventables.com Inventables Forum] | ||
*[http://forum.vectric.com VCarve Forum] | *[http://forum.vectric.com VCarve Forum] | ||
Revision as of 11:05, 22 June 2017
Location: Wood Zone
Spindle (DeWalt 611), 7.0 Amps, 1-1/4HP No load speed: 16,000-27,000rpm. A properly tuned and calibrated machine should get to a resolution of ~0.075mm to 0.13mm.
Contents
HELP
Open VCarve
- Open Model (*.xxx)
Select Tool
- Existing Tool: Select tool
- New Tool:
1. Measure Tool
Save Toolpath
- EMC2 Arcs(inch} (*.ngc)
Load Material
- Use carpet tape (or other 2x-sided tape)
Load Tool
- Unscrew Spindle
- Load Tool
- Lock Spindle
- Hand tighten
- Spindle Tool tighten
- Put spindle tool away
Setup
- Turn Spindle Off
- Apply Safety Glasses
- Turn Machine On
- Hold down |Shift| to run as Admin
- Open Joy-To-Key
- Open CNC USB Controller
- File->Import GCode
Zero Tool
- Jog Tool to your material origin
- Z down almost to material
- Using paper, step down until paper hard to move
- ->Machine->Offset->Current XY
- ->Machine->Offset->Current Z
- ->Machine->Zero XY
- ->Machine->Zero Z
Final Check
- Apply Safety Glasses
- Install Dust Collection
- Turn Dust Collector On
- Turn Spindle On
- Press START
- Monitor part w ESTOP & Pause
- Override Feed Rate if going too slow
