Chevy Volt Battery Documentation

From MakerFX Wiki!
Revision as of 04:35, 4 December 2017 by Ian (talk | contribs) (Charging PPPRS 48v Modules)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Overview

We purchased a Chevy Volt Battery (Gen 1) for $999 from M&K Auto Parts in Orange City, Fl on November 6, 2017. This battery will be torn down to individual modules to be used for new Power Racing Series vehicles for the 2018 season. We are expecting to get seven 48v modules, and two 24v modules from the Volt battery. These modules are heavy (~50 pounds), but should have enough power to not require a battery swap for any race including the 90 minute endurance race.

The 48v modules are 12s3p configuration, however we are modifying them to be able to separate into two 6s3p packs so that we can use inexpensive dual 6s chargers.

Flickr album of all Ian's photos

Drew volt battery.jpg

Battery Information

Volt battery gen1 overview.png


Chevy Volt Summary.png

Teardown

How to

How NOT to

Tools we used

  • Plastic sheeting, Bucket, Rags - there is residual coolant. Not much, but it gets everywhere. Drain at each opportunity
  • 10mm nut driver on a cordless impact driver - The deeper the better
  • 10mm socket on a socket wrench and on the cordless impact driver - for the places the nut driver wasn't deep enough
  • Torx T-30 bit and driver - there are four Torx screws on the top of the battery enclosure by the quick disconnect.
  • Prying screwdriver
  • Knife - sliced the short coolant hoses, and the tape that holds the battery modules down on the side with the mounting bolts
  • Duct Tape - taped the covers so that we'd know where to cut them with the bandsaw
  • Bandsaw - cut the covers so that we could move each battery module with a cover on it
  • Parts tray - lots and lots of bolts & nuts come off the battery assembly
  • Sharpie - Label all the things
  • Solid wire - to bind the modules together after removing the rods that hold multiple modules together. You might want to have threaded rod ready, but this worked.
  • Big pliers - for twisting the wire to compress the modules after removing the rods
  • Gloves - Reduce shock hazard (maybe) and helps with residual coolant and sharp edges.

You might consider

  • Non conductive tape, or other material to cover the pack bus bars while the top covers are off. I had a really hard time remembering to NOT touch the top of the pack while the covers were off.

Teardown notes to review before jumping in

  • LOTS OF HOT POINTS. BE CAREFUL
  • Label the BMS modules with each pack - they differ

Volt battery pose.jpg

OEM Battery Management System

Charging PPPRS 48v Modules

We have confirmed that we can split the 12s pack into two 6s packs for dual charging, however this requires some work with a Dremel tool that is somewhat dangerous. (Note: as of 12/4/2017, we've split one pack electrically, and done a low amp charge for over an hour - but have not moved up to high amp charging yet as we need to get better main charging cables built)

(TODO: Pics of the 6/7 tab, and the bus bar for pin 6, and how to separate them)

Examples of Volt Battery Usage

Got extra time?