How to use the Epilog Laser Rotary Tool

(work in progress)

Please check laser materials chart.

DO NOT ETCH BOTTLES FILLED WITH LIQUID, ETC.

Important Notes:

• DO NOT CONNECT OR DISCONNECT THE ROTARY TOOL WITH THE LASER ON. It can damage the main board which is more than $1k
• Lower the bed and DO NOT place your item on the rotary too before powering the laser on. The laser head homes over the tool and you will crash the head into your part of it is on the rotary tool and not the bed is not low enough.

The Epilog Laser Rotary Tool lives in a plastic bin on the shelf under the laser. There should also be a small bubble level that lives in that bin (As of 2/1, currently missing)

Rough Steps:

• Power up the laser
• Turn off X/Y using the control panel
• Open the full lid of the laser
• Using the focus buttons on the left side, lower the bed about 6" or so
• Flip the rulers back
• Remove the vector grid carefully and place it somewhere safe standing up. The vector grid may be dirty, but it is expensive
• Remove the left two vector grid supports and move them to the right side, there are two additional notches to store them on the right side
• If there is a lot of debris, this would be a good time to vacuum out the laser.
• POWER OFF THE LASER
• Place the rotary tool in the laser. There are three pins on the bottom of the rotary tool that go into holes for those pins.
• Plug in the rotary tool. MAKE SURE THE LASER IS OFF FIRST!
• MAKE SURE YOUR PART IS NOT ON THE ROTARY TOOL.
• Power up the laser - The laser will now home the laser head over the rotary tool - If it looks like the head will crash, turn off the laser using the main power switch.
• Turn off X/Y using the control panel
• Place your part on the rotary tool. If this is a cup, etc.