Difference between revisions of "Sheldon Metal Lathe"
(Created page with " TS-44 E model number.... * T - Indicated a taper attachment or tapered roller spindle bearings * S - Later 11” swing (clearance measures at an actual 11-1/4” over the bed...") |
|||
| Line 1: | Line 1: | ||
| + | [[File:Sheldon-Metal-Lathe-TS44E.jpg|400px|thumb|right]] | ||
| − | TS-44 E model | + | |
| + | =TS-44 E model= | ||
* T - Indicated a taper attachment or tapered roller spindle bearings | * T - Indicated a taper attachment or tapered roller spindle bearings | ||
* S - Later 11” swing (clearance measures at an actual 11-1/4” over the bed and carriage wings), “short” #5MT spindle taper; 2-1/4” x 8 TPI spindle thread | * S - Later 11” swing (clearance measures at an actual 11-1/4” over the bed and carriage wings), “short” #5MT spindle taper; 2-1/4” x 8 TPI spindle thread | ||
| Line 7: | Line 9: | ||
| − | Spindle Speeds - 8 speeds | + | =Spindle Speeds - 8 speeds= |
* Back gears engaged: 50, 87, 142, 244 | * Back gears engaged: 50, 87, 142, 244 | ||
* Open belt: 280, 482, 788, 1355 | * Open belt: 280, 482, 788, 1355 | ||
| − | Capacity and Clearances | + | =Capacity and Clearances= |
* Swing over bed - 11 1/4 | * Swing over bed - 11 1/4 | ||
* Swing over cross slide - 8” | * Swing over cross slide - 8” | ||
| Line 21: | Line 23: | ||
* Bed height - 6 9/16” | * Bed height - 6 9/16” | ||
| − | Headstock | + | =Headstock= |
* Hole through spindle - 1 3/8” | * Hole through spindle - 1 3/8” | ||
* Large face plate diameter - 11” | * Large face plate diameter - 11” | ||
* Small dog plate diameter - 5 1/2” | * Small dog plate diameter - 5 1/2” | ||
Revision as of 16:33, 4 June 2021
TS-44 E model
- T - Indicated a taper attachment or tapered roller spindle bearings
- S - Later 11” swing (clearance measures at an actual 11-1/4” over the bed and carriage wings), “short” #5MT spindle taper; 2-1/4” x 8 TPI spindle thread
- 44 - Bed length in inches
- E - 4 speed under drive with 4 step pulleys (or possibly 8 speeds if the primary pulley has two steps instead of 1.
Spindle Speeds - 8 speeds
- Back gears engaged: 50, 87, 142, 244
- Open belt: 280, 482, 788, 1355
Capacity and Clearances
- Swing over bed - 11 1/4
- Swing over cross slide - 8”
- Distance between centers - 35”
- Carriage length - 13”
- Carriage bridge wide - 4 1/2”
- Bed length - 44”
- Bed width - 8”
- Bed height - 6 9/16”
Headstock
- Hole through spindle - 1 3/8”
- Large face plate diameter - 11”
- Small dog plate diameter - 5 1/2”
