How to focus the Epilog Laser

Follow these steps to power on the Epilog laser and get it ready for a job.

Note that text inside of [] is a key on the laser control panel.

• Power On
  • Switch is located front left
• Use correct table
• Focus laser
  • Press [XY Off] + [GO]
  • Manually move the laser to near the center of material - exact location is not important
  • Press [Pointer] ON to help
  • Remove and position the focus tool so the tool (triangle) is pointing down
  • Adjust table so the focus tool just touches the material
    • Press [Down Arrow] or [Up Arrow] as needed
  • Manually move the laser to the top left of the material - this will be 0,0
  • Press [Set Home]
  • Note XY will be ON at this point
• Confirm Home Position (0,0) (optional step)
  • Press [XY Off]
  • Manually move laser to some point on your material
  • Press [Reset]
  • Laser should automatically move to 0,0
• Warm Up
  • Press [Maint]
  • Press [Down Arrow]
  • Select #2 (Align laser) - Press [Enter]
  • Close lid
  • Press [Up arrow]
  • Press [Stop] 2x times

You can now send (print) your job to the laser.