Difference between revisions of "Forest CNC Startup"
(→4. Set CNC Home) |
|||
| Line 9: | Line 9: | ||
=== 4. Set CNC Home === | === 4. Set CNC Home === | ||
| + | *Using the CNC software on the laptop... | ||
*Click the Big Red Reset button | *Click the Big Red Reset button | ||
| − | *Press Reset Home | + | *Press the Reset Home button |
*Machine cycles through X, Y & Z limits | *Machine cycles through X, Y & Z limits | ||
*X, Y & Z coordinates should all read 0 (zero) - look bottom left of the screen | *X, Y & Z coordinates should all read 0 (zero) - look bottom left of the screen | ||
Revision as of 16:46, 8 February 2021
Follow these steps to startup the CNC from a powered off position.
Contents
1. Turn on the computer
2. Turn on the CNC controller using the green button
3. Verify gantry in Parked position
- Gantry should be at the far end of the table away from the computer ===
- If not, using the CNC controls, move the gantry to the other end of the table
- DO NOT go all the way to the end, but come within a few inches
4. Set CNC Home
- Using the CNC software on the laptop...
- Click the Big Red Reset button
- Press the Reset Home button
- Machine cycles through X, Y & Z limits
- X, Y & Z coordinates should all read 0 (zero) - look bottom left of the screen
SUCCESS
- You have successfully powered up the CNC and set the machine home position
- The next step is to set your job home position
