Forest CNC Startup
Follow these steps to startup the CNC from a powered off position.
Contents
1. Turn on the computer
2. Turn on the CNC controller using the green button
3. Verify gantry in Parked position
- Gantry should be at the far end of the table away from the computer ===
- If not, using the CNC controls, move the gantry to the other end of the table
- DO NOT go all the way to the end, but come within a few inches
4. Set CNC Home
- Click the Big Red Reset button
- Press Reset Home
- Machine cycles through X, Y & Z limits
- X, Y & Z coordinates should all read 0 (zero) - look bottom left of the screen
SUCCESS
- You have successfully powered up the CNC and set the machine home position
- The next step is to set your job home position
